Penofin penetrating oil wood finish is formulated to enhance and protect the natural beauty of any variety of wood. Use Penofin oil wood finish on any exterior wood surface where a transparent finish with ultraviolet protection is needed.  Free 2oz Sample

Blue Label Oil Wood Finish is available in ten colors.
Blue Label Oil Wood Finish Application Tips
# SHAKE PRODUCT WELL BEFORE USING. DO NOT add thinning or blending agents.
# Apply Penofin to a clean, dry surface. Surface must be free of dirt and sawdust build-up. DO NOT APPLY IN DIRECT, HOT SUNLIGHT (when wood is hot to the touch).
# Brush on, use a stain pad, or spray on (garden or pump airless sprayers) one coat of Penofin.
# For maximum penetration wait 30 minutes, then use a nap-free shop cloth and wipe the entire surface removing any excess product.
# Surface will be dry to the touch in three hours and ready for use in 12 hours
# When using the one-coat formula, the application is now complete.
# If using the two-coat formula, wait a minimum of three hours and apply a light second coat and again wipe any excess from the entire application area.

Caution & Warnings
# Combustible - keep this product away from heat, open flame, and sparks.
# Beware of spontaneous combustion. Make certain all rags or other materials used with Penofin are soaked in water, stored in an air-tight container, or otherwise disposed of safely.

Gallon Coverage
Smooth surfaces: 200-300 square feet. Rough surfaces: 125-175 square feet (a gallon) for both coats of Oil Wood Finish.

Product Performance
Expect 2-4 years on vertical surfaces, 9-18 months on horizontal surfaces depending on use and weather exposure.