Messmer's Timberflex Pro is a two coat film forming system which gives a beautiful, varnished satin appearance to exterior log and timber frame wood homes.
Do not begin the process until you have read and understand all instructions. If you have any questions, call us toll free at 1-800-731-3669, weekdays 8-5 Mountain time. Do not apply if rain is expected within 48 hours. In certain climates you may have to wait for a different time of year to do this. Surface temperature should be at least 50 F and not more than 90 F. We recommend doing a test area on your project to insure your satisfaction with color choice before proceeding with the entire job.
Timberflex PRO is for vertical surfaces only. Do not use on decks or any other walking surface.
Start with a clean surface
Make sure the wood surface is clean, dry and in good condition. If necessary, use a good quality wood cleaner to prepare the surface. Any loose, peeling or flaking previous finish should be removed.
Apply the first coat. Cover plants, grass, concrete, trim, and any other areas you don't want finished. Stir product thoroughly, making sure that all pigment is mixed evenly and there is no thick material at the bottom of the container. Apply one coat of Timberflex PRO in your choice of colors following label directions. If spraying, it is recommended to "back brush" or roll the product to make sure that it fully penetrates into the wood. Allow at least 24 hours in good weather for the product to dry. A slightly tacky feel will be normal betweeen coats.
Apply a second coat of the same product Apply a second coat of Timberflex PRO in the same color. Product will begin to build a film on the wood with the second coat. Allow at least 24 hours to dry, in good weather conditions. Cooler temperatures may require longer drying times.
Clean up Following label directions, dispose of waste including roller covers and brushes in a water filled container. Seal the container and dispose of it properly.
|
