100 VOC version for Southern California. Penofin Finish for Hardwood is used for all fine hardwoods such as IPE, Pau Lope®, Ironwood™, Mahogany, and Teak.
Hardwood Formula Application Tips
# SHAKE PRODUCT WELL BEFORE USING. DO NOT add thinning or blending agents.
# Apply Penofin to a clean, dry surface. Surface must be free of dirt and sawdust build-up. DO NOT APPLY IN DIRECT, HOT SUNLIGHT (when wood is hot to the touch).
# Brush on, use a stain pad, or spray on (garden or pump airless sprayers) one coat of Penofin.
# For maximum penetration, wait 20-30 minutes, then use a nap-free shop cloth and wipe the entire surface, removing any excess product.
# Surface will be dry to the touch in three hours and ready for use in 12 hours
# The application is now complete.
Caution & Warnings
# Combustible - keep this product away from heat, open flame, and sparks.
# Beware of spontaneous combustion. Make certain all rags or other materials used with Penofin are soaked in water, stored in an air-tight container, or otherwise disposed of safely.
Gallon Coverage
400-500 square feet.
Maintenance
A maintenance coat of Hardwood Finish should be applied within 3-6 months after the initial application or as soon as oil looks depleted. The next maintenance coat should be done again in approximately 10-12 months or whenever oil looks depleted. Over time, the wood fibers become fully protected and the maintenance will become less frequent. Wash the wood with a mild cleanser and warm water. Rinse well. Allow wood to dry for a minimum of 48 hours before application. Apply maintenance coat of Hardwood Finish. After 20-30 minutes of absorption time, wipe the surface with a nap-free, clean, dry cloth.
|
